2.0" 320x240 Color IPS TFT Display with microSD Card Breakout

2.0" 320x240 Color IPS TFT Display with microSD Card Breakout
Levertijd 10 tot 30 werkdagen
Op voorraad bij leverancier
Vandaag besteld, ongeveer vrijdag 4 september in huis.
Verzonden vanaf  € 6,95 - België
Verkocht per stuk
€ 25,15
In winkelwagen
  • Koop 10 stuks voor € 24,45 per stuk3% korting
  • Koop 25 stuks voor € 23,80 per stuk5% korting
  • Koop 50 stuks voor € 23,10 per stuk8% korting
  • Koop 100 stuks voor € 22,40 per stuk11% korting
  • Koop 500 stuks voor € 21,75 per stuk14% korting


This gorgeous IPS display breakout is the best way to add a small, colorful and bright display to any project, with excellent visibility from any angle. Since the display uses 4-wire SPI to communicate and has its own pixel-addressable frame buffer, it can be used with every kind of microcontroller. Even a very small one with low memory and few pins available!

The 2.0" display has 320x240 color pixels. Unlike the low cost "Nokia 6110" and similar LCD displays, which are CSTN type and thus have poor color and slow refresh, this display is a true TFT! Not only that, but its an IPS display for vivid color and high-angle visibility. The TFT driver (ST7789) can display full 18-bit color (262,144 shades), but almost all drivers will use just 16-bit color. The TFT will always come with the same driver chip so there's no worries that your code will not work from one to the other.

The breakout has the TFT display soldered on (it uses a delicate flex-circuit connector) as well as a ultra-low-dropout 3.3V regulator, auto-reset circuitry, and a 3/5V level shifter so you can use it with 3.3V or 5V power and logic. We also had a little space so we placed a microSD card holder so you can easily load full color bitmaps from a FAT16/FAT32 formatted microSD card. The microSD card is not included, but you can pick one up here.

Of course, we wouldn't just leave you with a datasheet and a "good luck!" - we've written a full open source graphics library that can draw pixels, lines, rectangles, circles, text and bitmaps as well as example code. The code is written for Arduino but can be easily ported to your favorite microcontroller! Wiring is easy, we strongly encourage using the hardware SPI pins of your Arduino as software SPI is noticeably slower when dealing with this size display.

Vraag en antwoord


2.0" 320x240 Color IPS TFT Display with microSD Card BreakoutKlik op een ster om een beoordeling te geven

Laatst bekeken