Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini Kit

Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini Kit
Levertijd 3 tot 10 werkdagen
Vandaag besteld, ongeveer dinsdag 10 maart in huis.
Verzonden vanaf  € 25 - United States
Verkocht per stuk
€ 19,95
In winkelwagen
  • Koop 10 stuks voor € 19,75 per stuk1% korting
  • Koop 25 stuks voor € 19,60 per stuk2% korting
  • Koop 50 stuks voor € 19,40 per stuk3% korting
  • Koop 100 stuks voor € 19,20 per stuk4% korting
  • Koop 500 stuks voor € 19,05 per stuk5% korting


The Raspberry Pi is a wonderful little computer, but one thing it isn't very good at is controlling DC Servo Motors - these motors need very specific and repetitive timing pulses to set the position. Instead of asking the Pi Linux kernel to send these signals, pop on this handy HAT! It adds the capability to control 16 Servos with perfect timing. It can also do PWM up to 1.6 KHz with 12 bit precision, all completely free-running.

For use with Raspberry Pi Model Zero, A+, B+, Pi 2 or Pi 3 (any Pi with 2x20 header)

The Adafruit 16-Channel 12-bit PWM/Servo HAT will drive up to 16 servos or PWM outputs over I2C with only 2 pins. The on-board PWM controller will drive all 16 channels simultaneously with no additional Raspberry Pi processing overhead. What's more, you can stack up to 62 of them to control up to 992 servos - all with the same 2 pins!

Works with any servo that can be powered by 5V and take 3.3V logic level signals.

Best of all, we even have a Python library you can use, so you'll be up and running instantly, to make your robotic creation com to life. The Adafruit PWM/Servo HAT is the perfect solution for any project that requires a lot of servos or PWM outputs! 

Each order comes with a Servo HAT, a 2-pin terminal block, four 3x4 headers and a 2x20 socket header. You'll need to do some light through-hole soldering to attach the headers onto the HAT circuit board, but its easy to do with basic soldering tools like a soldering iron and rosin core electronics solder. If you would like to stack multiple HATs onto one Pi, you can also pick up a 2x20 stacking header and a set of right-angle 3x4 headers that should be soldered on instead.

Please note!This kit does not come with Raspberry Pi, servos, or required 5V power supply.

Vraag en antwoord


Er zijn nog geen beoordelingen achtergelaten voor dit product .

Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini KitKlik op een ster om een beoordeling te geven